Yamato Scientific Hitech controller type Ⅳ - Manual (Page 22)

20
Temporary Suspension of Program Operation Temporary Suspension of Program Operation Temporary Suspension of Program Operation Temporary Suspension of Program Operation
Temporary suspension of program operation means to stop the program timer and
temporarily keep the programmable controller at the status of ready-for-operation.
During the suspension, the programmable controller shuts off power supply to heaters
and does not regulate chamber temperature.
[Suspending Program Operation Temporarily] [Suspending Program Operation Temporarily] [Suspending Program Operation Temporarily] [Suspending Program Operation Temporarily]
Key
Operatio
n
Main
Display Sub Display Explanation
Push
Operatio
n Menu
key If you push Operation Menu key during the
program operations the main display shows
(Pause) while the sub display
shows the ongoing program number. When
you want to cancel Temporary Suspension of
Program Operation, leave the programmable
controller for 20 seconds or push ESC key.
(Lighting)
Approx. 1 second later
ｅ.ｇ.,
↑↓
Alternate
indicator.
Push
ENTER
key. Suspends program operation temporarily. Suspends program operation temporarily. Suspends program operation temporarily. Suspends program operation temporarily.
The main display shows chamber
temperature, while the sub display
alternately shows , and the program number
(left 2 digits) and the ongoing
segment number (right 2 digits).
Ready indicator lamp Rashes on the
operation monitor.
[Restarting Program Operation] [Restarting Program Operation] [Restarting Program Operation] [Restarting Program Operation]
Push Operation Menu key and operation starts again automatically. If chamber
temperature deviated from the preset temperature during the suspension of operation,
the sub display flashes its indication. When chamber temperature reaches the desired
temperature, the operation timer starts again and the sub display shows the correct
temperature.
Important Important Important Important
Program input, Edit and Delete modes can be activated only during the program
operation, and they do not work in the fixed-value operation and the automatic
star/stop operation. These modes can work when you have pushed Operation Menu key
at the status of ready-for -operation, including temporary suspension of program
operation. When the programmable controller is on the mode which cannot execute
Program input, Edit and Delete, pushing MODE key skips the indication of these
modes.