3D Robotics X8 Plus - Manual (Page 34)

32
Appendix: Troubleshooting
Maintenance
Pre-Arm Safety Check Failure
`
If the status LED displays blinking yellow, the X8 is failing one the pre-arm safety checks. To determine the specific failure, check the
heads-up display on the ground station. There will be an error message specifying the failed check.
Radio Calibration Failure: Perform Radio Calibration or RC controller re-binding
Accelerometer Calibration Failure: Perform Accelerometer Calibration
Compass Calibration Failure: Perform Compass Calibration
GPS Failure: Wait for improved GPS signal or move to a more open area
Video tutorials for performing calibrations can be found at 3DR.com/X8/info.
Replacement parts for the X8 can be purchased at store.3DR.com.
Instructions for replacing the wiring, plates, motors, and legs of the X8 can be
found at 3DR.com/X8/info.