Rockwell Automation 20P PowerFlex DC Drive - Frame C Transient Noise Filter Circuit Board User Manual
Page 8
8
PowerFlex® DC Drive - Frame C Transient Noise Filter Circuit Board
9. Remove the wires from the Transient Noise Filter board that are
connected to the back of the control terminal blocks on the Power
Supply Filter board.
10. Remove the two screws that secure the top of the Power Supply Filter
board and carefully lift the board up and away from the W phase power
terminal.
11. Temporarily raise and secure the EMI Shield and Control board and
remove the screws that secure the black leads from connections V and
W on the Transient Noise Filter board to power terminals V and W,
respectively, and remove the leads.
Remove wires
Remove screw
Remove screw
Remove screws and leads
Note: Drive shown with
Transient Noise Filter
board and Power Supply
Filter board still secured