Hazardous location considerations, Overview, Hazardous location considerations overview – Rockwell Automation 20D-DL2-CL3 DriveLogix Controller Compact I/O Cable User Manual
Page 3

Compact I/O Cable for DriveLogix™5730 Controller 3
Publication 20D-IN008B-EN-P - August 2004
If you would like a manual, you can:
• download a free electronic version from the internet:
www.rockwellautomation.com/literature
• purchase a printed manual by:
– contacting your local distributor or Rockwell Automation representative
Hazardous Location Considerations
This product must be installed in an enclosure. This equipment is suitable for use in Class I,
Division 2, Groups A, B, C, D or non-hazardous locations only. The following
ATTENTION statement applies to use in hazardous locations.
EXPLOSION HAZARD
• Substitution of components may impair suitability for Class I,
Division 2.
• Do not replace components or disconnect equipment unless power
has been switched off or the area is known to be non-hazardous.
• Do not connect or disconnect components unless power has been
switched off or the area is known to be non-hazardous.
• All wiring must comply with N.E.C. article 501-4(b).
Overview
The 20D-DL2-CR3 and 20D-DL2-CL3 cables allow you to connect a DriveLogix5730 Phase
II controller to a bank of Compact I/O. A maximum of two banks of I/O can be used a
DriveLogix5730 Phase II controller. Each bank requires its own power supply. See System
Configurations on page 5.
For
Refer to this Document
Pub. No.
Information on how to install and use
your 1769-IT6 module
Compact 1769-IT6 Thermocouple/mV Input Module
User Manual
1769-UM004
Installation guides for 1769
RTD/resistance module 1769-IR6
Compact 1769-IR6 RTD/Resistance Input Module
Installation Instructions
1769-IN027
Information on how to install and use
your 1769-IR6 module
Compact 1769-IR6 RTD/Resistance Input Module
User Manual
1769-UM005
Installation guides for 1769 power
supplies
Compact 1769 Expansion I/O Power Supplies
Installation Instructions
1769-IN028
Installation guides for 1769 cables
Compact I/O Communication Bus Expansion Cables
Installation Instructions
1769-IN014
Installation guides for 1769 end caps and
terminators
Compact I/O End Caps/Terminators Installation
Instructions
1769-IN015
ATTENTION
!