Rockwell Automation 20P PowerFlex DC Drive - Frame D Fan Starting Capacitor User Manual
Rockwell Automation Equipment
PowerFlex® DC Drive
Frame D Fan Starting Capacitor
Installation Instructions
What This Kit Includes
• Fan starting capacitor
• Static strap
Tools That You Need
• Hexalobular screwdriver
• Flathead screwdriver
What You Need to Do
The fan starting capacitor is mounted on the drive frame behind the top front
protective cover of the drive. To install the fan starting capacitor:
❐ Step 1: Remove power from the drive
❐ Step 2: Remove the top protective cover
❐ Step 3: Remove the existing fan starting capacitor
❐ Step 4: Install the new fan starting capacitor
❐ Step 5: Replace the top protective cover and document the change
ATTENTION: Only qualified personnel familiar with DC drives
and associated machinery should plan or implement the installation,
start-up and subsequent maintenance of the system. Failure to comply
may result in personal injury and/or equipment damage.
ATTENTION: To avoid an electric shock hazard, ensure that all
power to the drive has been removed before performing the following.
ATTENTION: This drive contains ESD (Electrostatic Discharge)
sensitive parts and assemblies. Static control precautions are required
when installing, testing, servicing or repairing this assembly.
Component damage may result if ESD control procedures are not
followed. If you are not familiar with static control procedures,
reference A-B publication 8000-4.5.2, “Guarding Against
Electrostatic Damage” or any other applicable ESD protection
handbook.