Rockwell Automation 22-HIM-C2S PowerFlex 4-Class HIM (DSI) Quick Reference - Manual (Page 2)

Key Descriptions
Menu Navigation Tabs
Keys Description
Exit a menu, cancel a change to a parameter value, or acknowledge a fault/alarm.
Select a digit, select a bit, or select a menu tab.
Scroll through options, increase a value, or toggle a bit.
Scroll through options, decrease a value, or toggle a bit.
Enter a menu, enter edit mode in a parameter screen, or save a change to a parameter
value.
plus…
Toggle between the Process Display and Large Format Display.
Select an available language for text displayed on HIM screens.
Allow the HIM to be disconnected without causing a fault condition.
Enable direct parameter number entry.
Start the drive.
Stop the drive or clear a fault.
Change direction.
Jog the drive.
Type parameter numbers and values.
Increase or decrease the speed Reference to the drive after these keys are enabled by
setting drive parameter P038 - [Speed Reference] as follows:
• When the HIM is the DSI Master, set parameter P038 to “5” (Comm Port).
• When the HIM is the DSI Slave, set parameter P038 to “1” (Internal Freq).
To view the HIM’s active device type status (Master or Slave), see HIM Parameter 10 -
[M/S Status].
Tabs Description
DIAG The Diagnostics tab is used to display faults, the device (drive or peripheral) status, and device version.
PARAM The Parameters tab is used to edit parameters. Parameters can be displayed in groups, in a linear list,
or only those changed from their defaults.
DSEL The Device Select tab is used to select the device (drive or peripheral) that the HIM is to access.
MEM The Memory Storage tab is used for HIM CopyCat (uploading/downloading configurations to the HIM
EEPROM).
HIM The HIM Setup tab is used to access HIM parameters, view the HIM version, and to edit the Reference
text when a user-defined Reference is used.
Esc
Sel
Alt
Sel
View
Lang
Remove
+/-
Param #
Jog
... 0 9
. +/-