Rockwell Automation 20P PowerFlex DC Drive - Frame D Field Fuse Holder Replacement User Manual
Page 5
5
9. Remove the two hexalobular screws that secure the bottom of the fuse
holder to the control pan. Retain the screws for reuse.
10. Place the tip of a flathead screwdriver in the slot of the two tabs at the base
of the fuse holder and pull down until the tabs pull out from the fuse holder
body. When then fuse holder is loose, remove it from the metal support
flange.
11. With the tabs pulled out from the base of the new fuse holder, place it on the
metal flange and press up on the tabs until they lock into place behind the
metal support flange.
12. Install the two hexlaobular screws that secure the bottom of the fuse holder
to the control pan.
13. Install the fuses and the input and output wiring.
14. Replace all protective covers on the drive.
Pull tabs down and
remove fuse block
=
Remove screws