Rockwell Automation 20P PowerFlex DC Drive - Frame C Armature Circuit Fuse Replacement - Manual (Page 4)

4 PowerFlex® DC Drive - Frame C Armature Circuit Fuse Replacement
Step 3: Remove the
Existing Armature Circuit
Fuse(s) You must remove the Transient Noise Filter circuit board in order to remove
the fuses from the V phase input bus bars.
1. If you are replacing the V Phase Armature circuit fuse(s), remove the
two screws and washers that secure the bottom of the Transient Noise
Filter board to the drive.
2. Carefully disconnect the cables from connectors XFCD and XR on the
Control board.
=
Remove screws
Disconnect
cables