Rockwell Automation 20P PowerFlex DC Drive - Frame C Switching Power Supply Circuit Board User Manual
Page 7
Advertising
PowerFlex® DC Drive - Frame C Switching Power Supply Circuit Board
7
6. Remove the six screws and washers that secure the board to the Control
EMI shield and remove the board.
Important: DO NOT remove the Isolation shield below the board
unless it is damaged and you are replacing it with a new
sheet.
Step 4: Install the New
Switching Power Supply
Board
1. Install the new Switching Power Supply board in reverse order of
removal as detailed in Step 3:
Remove the Switching Power Supply
.
2. Replace the 16 Pin cable connected to connector XA on the Switching
Power Supply board with the new cable provided.
Remove six screws and washers
Front of drive
Advertising