Rockwell Automation 20P PowerFlex DC Drive - Frame C Field Dual Diode Module - Manual (Page 7)

PowerFlex® DC Drive - Frame C Field Dual Diode Module 7
Figure 1 Field Snubber Board Layout
Step 4: Remove the Field
Snubber Board and Existing
Field Dual Diode Module Important: Mark all connections and wires before removal to avoid
incorrect wiring during reassembly.
1. Remove the cable from connector X3 on the Field Snubber board.
2. Remove the seven screws, washers and wire leads (connections 2V1,
2U1 and 2C1 and one unmarked) from the board and remove the board
from the drive.
TA1
X3
1
XFCD
1
2U1 2V1
2C1 2C1
2D1 2D1
=
Remove screws
and washers
Remove screws
and washers
Remove cable