Rockwell Automation 20D-P2-SLBO PowerFlex 700S Drive Phase II Control SynchLink Board - Manual (Page 4)

4 Rockwell Automation Publication 20D-IN010B-EN-P - November 2010
SynchLink™ Board for PowerFlex® 700S Drives with Phase II Control
Step 3: Remove the
Control Cassette from the
Drive Frames 1…6
See page 3 for Frames 9…14 control cassette removal instructions.
1. If necessary, disconnect any fiber-optic ControlNet and SynchLink cables
from the control assembly.
2. Disconnect any remaining I/O and communications cables from the
control assembly.
3. Disconnect the ribbon cables that connect to the main control board.
4. Loosen the two screws on the front of the cassette.
5. Remove the cassette from the drive chassis.
ATTENTION: Hazard of permanent eye damage exists when using optical
transmission equipment. This product emits intense light and invisible
radiation. Do not look into fiber-optic ports or fiber-optic cable connectors.
BR1 BR2
DC+ DC-
PE
U/T1
V/T2 W/T3
R/L1
L2
=
Loosen two screws
Remove
cassette
Disconnect
ribbon cables