Rockwell Automation 20D-P2-SLBO PowerFlex 700S Drive Phase II Control SynchLink Board - Manual (Page 9)

Rockwell Automation Publication 20D-IN010B-EN-P - November 2010 9
SynchLink™ Board for PowerFlex® 700S Drives with Phase II Control
Step 8: Install the Control
Cassette in the Drive Install the control cassette in the reverse order of removal. Refer to Step 3:
Remove the Control Cassette from the Drive on page 4 .
Step 9: Connect the
SynchLink Cables Class 1 LED Product
• Connect the fiber-optic cables to the J1 (transmit) and J2 (receive)
connectors on the SynchLink board. Push the plug into the socket until it
produces an audible click.
ATTENTION: Hazard of permanent eye damage exists when using optical
transmission equipment. This product emits intense light and invisible
radiation. Do not look into module ports or fiber-optic cable connectors.
IMPORTANT Minimum inside bend radius for SynchLink fiber-optic cable is 25.4
mm (1 in.). Any bends with a shorter inside radius can permanently
damage the fiber-optic cable. Signal attenuation increases with
decreased inside bend radii.
IMPORTANT Do not overtighten tie-wraps.
J2 (Receive)
J1 (Transmit)
=