Rockwell Automation 20P PowerFlex DC Drive - Frame C Transient Noise Filter Circuit Board Fuse - Manual

Installation Instructions
PowerFlex
®
DC Drive - Frame C Transient Noise
Filter Circuit Board Fuse Replacement
What This Kit Includes
•
Three 6x32mm, 25A 500V fuses
•
Static Strap
What You Need to Do The Transient Noise Filter circuit board is located near the bottom of
the drive, behind the Control EMI shield. You must move the Control
EMI shield that holds the Control board in order to access the Transient
Noise Filter board and fuses.
1. Remove and lock-out all incoming power to the drive.
!
ATTENTION: To avoid an electric shock hazard, ensure that
all power to the drive has been removed before performing the
following.
Transient Noise Filter circuit board
L1 L2 L3
O
I