Rockwell Automation 800MR-x_MS-x Pilot Light and Push-To-Test Units - Manual (Page 2)

BULLETIN 800MS MOUNTING INSTRUCTIONS
PILOT LIGHT AND PUSH-TO-TEST UNITS
Step 1. Remove the lens assembly (or legend support) by
inserting a screwdriver between the assembly and
the bezel and gently pry the assembly out.
Step 2. If the two cam fasteners inside the bezel are
locked, turn them to their unlocked positions
(sloping surfaces facing each other and slots in
line). Pull the bezel off the unit.
Step 3. Select the proper number of gaskets for the panel
thickness and install them on the bushing. Note:
Use only the combination of gaskets specified in
Table 1 on the opposite side.
Step 4. Insert the bushing through the panel, and snap the
bezel on the bushing. The switch surface marked
"top", the locator tab on the rear surface of the
bezel and the anti-turn notch in the panel must be
in line.
Step 5. Fasten the unit on the panel by turning the two
cam fasteners 180˚ to their locked positions.
Step 6. Assemble the legend plate and lens by pushing
the lens through the hole in the legend plate from
the rear. Then slide the legend support into the
slots in the legend plate from the side, so that the
plate is centered on the support.
Step 7. Snap the lens assembly into the bushing in the
proper orientation. Note: See Step 1 for lens
assembly removal, if required.
Step 8. Check for proper installation by pushing on the
lens assembly.
If the unit is pushed out of the bezel, or is loose on the
panel, check for the proper combination of gaskets (Step 3),
and the proper cam fastener engagement (Step 5).
Push-To-Test Units: If the lens assembly does not return
freely, check for the proper combination of gaskets (Step 3).
Note: To remove the entire unit from panel, reverse Steps
4, 5 and 7.
BULB REPLACEMENT INSTRUCTIONS
1. Remove the lens assembly as described in Step 1.
2 . R e m o v e t h e b u l b b y p u s h i n g a n d t u r n i n g i t
counterclockwise using the small end of the bulb
remover (Allen-Bradley Catalog Number 800T-N82),
and insert a new bulb using the same action in the
clockwise direction.
3. Snap the lens assembly back into the bushing.
ATTENTION: This step must be completed to securely
fasten the unit on the panel, and to compress the gaskets
behind the panel.
40060-008-01 (A)
Printed in U.S.A.
Lens Assembly
Operator
Assembly
Panel
Gaskets
Legend Plate
Lens
Anti-Turn
Notch Cam
Fasteners
Legend
Support
Bushing
Bezel
B-vertical.ai
CONFIDENTIAL AND PROPRIETARY INFORMATION. THIS DOCUMENT
CONTAINS CONFIDENTIAL AND PROPRIETARY INFORMATION OF
ROCKWELL AUTOMATION, INC. AND MAY NOT BE USED, COPIED OR
DISCLOSED TO OTHERS, EXCEPT WITH THE AUTHORIZED WRITTEN
PERMISSION OF ROCKWELL AUTOMATION, INC.
BULLETIN 800MS AN 800MR
PILOT LIGHT AND PUSH-TO-TEST
INSTALLATION INSTRUCTION SHEET
40060-008
Sheet
Size Ver
Of 2 2
B 02
Dr. Date - - - - - - - - - - - -
MATERIAL
NO.
MATERIAL
SIZE
FOLD FLAT
4-7/8" W x 5" H 1-7/32" W x 5" H
TWO SIDES PRINTED
BODY STOCK WHITE
BODY INK BLACK
-01
SUPERSEDES
- - - - - - - -