Rockwell Automation 194RC-Nxxxx NFPA 79 Compliant Cable Operated Disconnect - Manual

ATTENTION: To prevent electrical shock, disconnect from power source before installing or servicing. Install in
suitable enclosure. Keep free from contaminants.
Fuse cover must be installed for safe operation.
Check that disconnect switch is in OFF position before assembly.
The Cable Operated Mechanism provides a means of externally operating the disconnect switch and can be applied
to enclosures of varying heights and depths. The handle can be used with NEMA 1, 3R, 12, 4, 4X enclosure
applications, depending on the accessory components selected. An operating handle, flexible cable, and
mechanism are required for standard application. Different lengths of cables are available for use with the wide
range of depths of various enclosures (3' through 10'). When selecting the length of the Flexible Cable, ensure
Minimum Bending Radius of 6 inches is maintained to operate properly. (See Figure 1-2). The standard method of
shipment includes the mechanism preset at the factory. If minor field adjustments are required see Figure 1-5.
(Cat 194RC-NJ030P3, -NJ030P4, -NJ030P6, -NJ030P10, -NJ060P3, -NJ060P4, -NJ060P6,
-NJ060P10, -NC030P3, -NC030P4, -NC030P6, -NC030P10, -NN030P3, -NN030P4, -NN030P6,
-NN030P10,-NN060P3, -NN060P4, -NN060P6, -NN060P10, -NJ030M3, -NJ030M4, -NJ030M6,
-NJ030M10, -NJ060M3, -NJ060M4, -NJ060M6, -NJ060M10, -NC030M3, -NC030M4, -NC030M6,
-NC030M10, -NN030M3, -NN030M4, -NN030M6, -NN030M10, -NN060M3, -NN060M4,
-NN060M6, -NN060M10, -NJ030S3, -NJ030S4, -NJ030S6, -NJ030S10, -NJ060S3, -NJ060S4,
-NJ060S6, -NJ060S10, -NC030S3, -NC030S4, -NC030S6, -NC030S10, -NN030S3, -NN030S4,
-NN030S6, -NN030S10, -NN060S3, -NN060S4, -NN060S6, -NN060S10)
NFPA 79 Compliant Bulletin 194RC Cable Operated Disconnect
General Information
1. Install disconnect switch with four #10-32 screws. (See Figure 1-1).
Bulletin 194RC Installation
ATTENTION: Before any installation or maintenance is performed, make sure that the disconnect switch is not energized.
Attach disconnect mechanism to enclosure back
panel using #10-32 screws through mounting holes
Figure 1-1 Attaching Disconnect to Enclosure Back Panel