Rockwell Automation 509 Full Voltage Starter - Size 8 (Series B Construction) - Manual (Page 6)

Page 6 of 10
BULLETIN
505 z 509
Bulletin 592 Manual Reset Overload Relay
Optional: Bulletin 193 E1 Plus Solid State Overload
Relay
(See Page 5)
ORDERING INFORMATION – Your order cannot be
entered unless the following information is given:
Part number, description of part and series letter of
starter. This renewal parts list applies also to these
starters when used on control apparatus listed under
other Bulletin numbers.
BULLETIN 1495 AUXILIARY CONTACT KITS
Catalog Number 1495-J6 (Single Contact)
Catalog Number 1495-K6 (Double Contact)
MOUNTING INSTRUCTION – To mount the Bulletin
1495 Auxiliary Contact place the auxiliary contact
operating lever into the auxiliary contact actuator
fastened to the cross bar. Tighten the two mounting
screws on the auxiliary contact to the coil cover. The
cross bar will now engage the operating lever of the
auxiliary contact.
CHANGING BULLETIN 1495 AUXILIARY CONTACT
FROM NORMALLY OPEN TO NORMALLY CLOSED
AND VICE VERSA
– To change the Bulletin 1495
Auxiliary Contact from Normally Open to Normally
Closed and vice versa, first loosen the screw which
holds the drive plate and adjusting plate together.
Then lift the drive plate as shown in the illustration.
Now rotate the adjusting plate to the opposite hole
and snap the drive plate into place. Then tighten the
screw. Double contact auxiliary switches have
isolated circuits; therefore, each side must be
adjusted independently.
TYPICAL WIRING DIAGRAM – (See applicable
codes and laws - Schematic is shown on page 7)
Overload Relay