Rockwell Automation 141A Mounting Ssystem MCS Star Tutorial - Manual (Page 11)

9
Once you select the [ Accept ] button below the catalog number, the starter drawing will be
added to the rack in the graphical interface, as well as the product detail in the bill of material.
You could confi gure the next starter by repeating the same steps for Motor 2. Since this is a
DOL starter, you would choose Bulletin 103S from the Product Library. After entering all the
starter parameters for Motor 2,
select the [ Accept ] button . Th e starter is then added to the
rack and BOM.
However, a faster method would be to “copy” the starter confi guration you just created and edit
the starter parameters
Since all the parameters for the next two starters (Motors 2 & 3) are very similar, you can copy
the starter for Motor 1 and edit the horsepower requirements. To copy a starter:
Click on the starter with the mouse cursor •
Press and hold the “Control” key and the left mouse button simultaneously •
Drag and drop the copy of the starter to the left •
Repeat this sequence one more time for Motor 3 •
Step 6:
Enter Starter
Parameters
(continued)
Step 7:
Copying
Components