Rockwell Automation 1326AB Cable Connector Seals - Manual

Publication 1326A-5.23 - March 1998
Installation Instructions
Connector Seals for Series B IP67 Cables
for IP67 Torque Plus Motors
Use these instructions to install the series B IP67 cable seals on the
power input connector and the resolver or encoder output connector of
existing 460V 1326 IP67 motors. The seals must be used with the
following cables:
• 1326-xxx-L
• 1326-xxx-RAL
• 1326-xxx-RBL
• 1326-xxx-EL
• 1326-xxx-DL
Determining the Tools You Need
You will need a phillips screwdriver to install the components of the
IP67 Cable Seal Kit for your existing IP67 motor.
Identifying the Components of the IP67
Cable Seal Kit
The components are:
• eight replacement connector screws
• seal for the power input connector
• seal for the resolver or encoder output connector
The top view of the IP67 seals that you received is shown below:
If you ordered this kit and did not receive these components, contact
your local Allen-Bradley representative.
Output connector
seal
Input connector
seal