Rockwell Automation 1609 UPS Management Software User Manual User Manual
Bulletin 1609 ups management software
Advertising
Table of contents
Document Outline
- Important User Information
- Preface
- Table of Contents
- Introduction
- 1609 UPS Management Software Installation
- 1609 UPS Management Software Setup:
- 1. Turn off your computer.
- 2. Attach the electrical power cable from the computer to the UPS.
- 3. Attach the electrical power cable from the UPS to an AC power outlet.
- 4. Plug the communication cable into the UPS, then plug the other end of the cable into the communication port on your computer.
- 5. Start your computer.
- 6. Place the CD in your CD-ROM device and execute the setup.exe to run the setup program.
- 7. Check the communication type of your UPS. If you select the USB option you must have connected the UPS to this computer and install the HID driver.
- 8. During the installation, the following dialog gives you 3 options:
- 9. After finishing the installation, setup program will create a 1609 UPS Management Software association.
- 10. The 1609 UPS Management Software is comprised of two modules:
- 1609 UPS Management Service
- 1609 UPS Management Monitor
- Networking
- Remote Monitoring and Control: 1609 UPS Management Monitor
- Remote Monitor and Control: Internet Browser
- 1609 UPS Management Monitor operation
- Top Layer Buttons
- 1609 UPS Management Monitor Main Menu
- System
- Login
- Monitor Screen
- Configuration
- Configuration Window
- 1609 UPS Management Software Setup:
- Devices
- UPS
- Network
- Control
- View
- Bottom Layer Buttons