Rockwell Automation 1400-SP PowerMonitor Software - Manual (Page 32)

Chapter 4
Using The Software
4–6
When connection cannot be made, the Powermonitor Software will
display:
UNIT NOT RESPONDING
If this occurs, there is a problem that is preventing communications from
being established. Determine and correct the problem and retry
connection by pressing the <Enter> key again while on the flashing
CONNECT OPTION field. Chapter 8 provides troubleshooting
information in case of difficulty.
2. Connecting via Telephone Modem. When using either of the two
modem line types, the Powermonitor Software will display the message:
DIALING
while dialing the telephone number entered in the DIAL (PHONE #)
field.
When the Powermonitor Software establishes communication with the
destination site, the Powermonitor Software will display:
MODEM CONNECTED ... Unit responding.
and the CONNECT OPTION will change to:
DISCONNECT
to allow disconnection, if desired.
If a connection cannot be made, then one of the following messages will
be displayed:
MODEM CONNECTED ... Unit not
responding.
MODEM NOT RESPONDING
NO CARRIER PRESENT
LINE BUSY
COMMAND ABORTED
MODEM ERROR
Pressing the ESC key will abort the dialing process and the following
message will be displayed:
CONNECTION ABORTED
Chapter 8 lists possible causes for the above difficulties.