Rockwell Automation 1394-DIM Installing Your Drive Interface Module - Manual (Page 5)

Installing Your 1394 Drive Interface Module 5
Publication 1394-5.12 — December 1999
5. Attach the terminator to the 1394-DIM and slide it to the left until
it locks into place, as shown in the figure below.
Figure 7
Attaching the Terminator
6. Install the lower fastener.
7. Tighten the upper and lower fasteners.
1394-DIM Configurations The identity and number of the axes you can connect to a 1394-DIM
depends upon the number of 1394 axis modules connected to your
1394 system in addition to the 1394-DIM.
The figure below shows the input connections located on the bottom
of a typical 1394 system and a 1394-DIM.
Figure 8
A 1394-DIM Connected to a GMC or GMC Turbo
A 1394x-SJTxx-C, -C-RL, -T, and -T-RL system module can control a
maximum of four physical axes. The 1394C-SJTxx-L and -L-RL can
control only one axis. Each 1394 axis module added to the 1394
system reduces the number of external drives and axes the 1394-DIM
can control by one.
Attaching the
Terminator
Rear of the units
Front of the units
Bottom of the
1394-DIM
Bottom of the
1394 GMC or 1394
GMC Turbo System
1394-DIM ground connector