Rockwell Automation 1336S_T_E DRIVE MTG GASKET - Manual (Page 4)

Bulletin 1336 PLUS, 1336 IMPACT, and 1336 FORCE

NEMA Type 4/12 Gasket Kit 1–4
Bulletin 1336–5.87 – November, 1997
To install the gasket, follow these steps:
1. Cut out the heatsink area.
2. Drill the mounting holes. Before drilling the mounting holes you
should make sure that they follow the appropriate drilling pattern
(Figures 1.1 to 1.6) and carefully read the Important on the first
page of this instruction sheet.
3. Clean and file the surface area to remove any burrs or sharp
edges.
4. Use paint to touch up all raw metal edges.
5. Place the gasket, with the gasket paper still intact, around the
cutout area on the inside of the enclosure and align the mounting
holes. The gasket holes are not equally spaced.
6. Peel away the gasket paper.
7. Firmly press the gasket in place with the adhesive towards the
chassis surface aligning mounting holes.
8. Remove the cover, mounting feet, and four side plates from the
drive.
9. Install the drive in the enclosure using the recommended
mounting screws. You should insert the screws through the drive
chassis to the outside of the enclosure.
10.Torque all mounting screws to the value shown in the table below.
Rating Number of Screws
Torque
N*m (in–lbs)
RF2 14 2.9 (26)
RF3 10 2.9 (26)
RF4 8 2.9 (26)
RF5 12 2.9 (26)
RF6 16 2.9 (26)
RF7 26 2.9 (26)
Installing the Drive Using
the Gasket Kit