Rockwell Automation 931S-T9C2D-DC Active Converter, Universal Thermocouple - Manual (Page 4)

4
3. Configuration
3.1 Equipment
A screwdriver with a width of 2.5 mm is required to adjust the unit and to
connect the wires to the terminals.
3.2 Opening the unit
Disconnect the plugs. Disengage the top part of
the housing by carefully pressing the latches on
both sides (1). Pull out the top part of the hou-
sing and the electronics section until they unlock
(2).
3.3 Settings
Set input and output ranges, minimum input
values and measuring span via the DIP switches
SW1 and SW2 according to the following tables.
When activating variable setting SW 1/8 of the
span or offset, it is possible to make additional
adjustments via front potentiometers span and
offset, accessible below cover (3).
1
1
2
Zero
Span
SW2 SW1
3