Rockwell Automation 1492 WinABMS Marking System Software - Manual (Page 29)

4-2 Using WinABMS Software
•
Help
The Tool Bar is shown below.
The Zoom Tools The WinABMS software has Zoom Tools that allow you to view the markers
in larger or smaller sizes.
1. Clicking on the Zoom In Tool will cause the markers to appear larger
on the monitor.
2. Clicking on the Zoom Out Tool will cause the markers to appear
smaller on the monitor.
3. Clicking on the Zoom All Tool will allow you to view all of the marker
cards on the current base plate.
4. Clicking on the Zoom 1:1 Tool will allow you to view the marker card in
its actual size at 800 x 600 monitor resolution.
5. Clicking on Zoom under the View heading will allow you to zoom in or
out by percentages.
Creating a New File This section shows how to create a new file.
To create a new file:
1. Click on New under the File heading or click on the New File Tool.
2. When the Base Plate Selection Menu appears, select the desired Base
Plate.
Note: Click on More to view additional base plate selections.
Create a new file Cut
Plot
Save a file
Open a file
Paste
Copy Undo Zoom In
Zoom Out
Zoom 1:1
Zoom All
Align Center Align Top Align
Bottom
Align Left Align Right Align
Middle
Layout 1
Layout 2
Display
Symbol Bar
Toggle
Help Replace
Font