Rockwell Automation 1492 WinABMS Marking System Software - Manual (Page 46)

6-6 Custom Marker Card Geometries
Test Plotting a Custom
Marker Card Geometry This section describes how to test plot a Custom Marker Card Geometry. This
is used to see whether matrix settings need to be adjusted.
To test plot a Custom Marker Card Geometry:
1. Click on Plot under the File heading or click on the Plot Tool.
2. When the Plot Settings Menu appears click on the baseplate slot where
you would like to test plot your marker card.
3. Click on the Plot Matrices Only Partially box if you only wish to plot
the perimeter markers for the selected marker area.
4. Click OK.
Deleting a Custom Marker
Card Geometry This section describes how to delete a Custom Marker Card Geometry.
To delete a Custom Marker Card Geometry:
1. Click on Open under the File heading or click on the Open Geometry
Tool.
2. Select the geometry to be deleted.
3. Click on Delete.