Rockwell Automation 1492-PRINT110_PRINT220 ClearMark Printer User Manual User Manual
Page 60
6-4
Rockwell Automation Publication 1492-UM008A-EN-P - June 2010
Chapter 6 First Time Use
Recommendations:
The ClearMark printer is now prepared for the first printing. Start up a new print
job with the ClearTools software.
Marker Type
Catalog Numbers
Color
Settings
600 dpi
1200 dpi
Snap-in individual markers:
1492-M, -MC, -MCS, -MN, -SM
White
H1
H1
1492-MCW
H2
H2
Snap-in linked markers
1492-MR
H2
H2
1492-MS
H1
H1
Snap-in hinged markers
1492-MH
H1
H1
Cable markers
1492-MW
H1
H1
Self-adhesive cable markers
1492-MWL
H1
H1
Wire markers
1492-MWC
All
Colors
H2
H2
Note: If Heating 1 causes bubbles on the surface, please change to Heating 2.
H1 = Heating 1, H2= Heating 2
ATTENTION: The required heat settings are dependent on
marker type, -color, -material and operating time of the
ClearMark printer. Please check the wipe and scratch resistance
in regular intervals.
ATTENTION: If a print job is unintentionally carried out without
heating it is possible to send an 'empty' print job to the printer
and set the correct heat settings H1/H2.