Rockwell Automation 1494V-M70_M7_M72 Variable Depth, Flange Operated Circuit Breaker Operating Mechani - Manual (Page 4)

Circuit Breaker Installation
Variable Depth, Flange Operated Circuit Breaker Mechanisms 4
4a
Publication 1494V-IN105E-EN-P - September 2014 PN-242292 DIR 10000787413 (Version 04)
23 - 37 lb-in
Go to Page 11 to assemble connecting rod and springs to handle
Verify that the disconnect handle and toggle on
the circuit breaker are in the “OFF” position.
Rotate connecting rod into drive bar
(10) full turns of engagement.
Attach toggle adjustment plate.
Press firmly in place.
Install circuit breaker operating
mechanism into panel. Choose proper insulation barrier
as labeled. Bend side panels of
insulation barrier inward.
Remove liner from two-sided tape.
Align holes on insulation barrier with holes on operating mechanism.
Install circuit breaker onto insulation barrier and mechanism.
140G-G; 140MG-G; 140G-I; 140MG-I
TA
P
E
23 - 37 lb-in
140G-I
140G-J
140G-G
140G-G 140G-I
140G-H
140G-J
140G-H
10 lb-in
1
2
3 4
L
L
R
5
6
9
7
8