Rockwell Automation 1494V-M70_M7_M72 Variable Depth, Flange Operated Circuit Breaker Operating Mechani - Manual (Page 8)

Variable Depth, Flange Operated Circuit Breaker Mechanisms 8
Circuit Breaker Installation (Cont'd)
4d
Publication 1494V-IN105E-EN-P - September 2014 PN-242292 DIR 10000787413 (Version 04)
Go to Page 11 to assemble connecting rod and springs to handle
90 - 130 lb-in
40 - 60 lb-in
140G-M; 140MG-M
8 Attach toggle adjustment plate
1
Verify that the disconnect handle and toggle on
the circuit breaker are in the “OFF” position.
2
Rotate connecting rod into drive bar
(10) full turns of engagement.
3 Install circuit breaker operating
mechanism into panel.
17 lb-in
6 Press firmly in place.
4
Install insulation barrier (provided with circuit breaker).
Remove liner from two-sided tape.
5 Align holes on insulation barrier with holes on operating mechanism.
7 Install circuit breaker onto
insulation barrier and
mechanism.
TA
P
E