Rockwell Automation 1609 Industrial Uninterruptible Power Supply - Series D - Manual (Page 2)

Bulletin 1609 Industrial Uninterruptible Power Supply
1. To access the battery compartment
remove the three screws and the
battery door.
3. Connect the red wire of the harness to
the positive terminal (top red) and the
black wire of the harness to the
negative terminal (bottom black).
See photo below for details.
5. To connect the batteries to the UPS, insert the batteries into the battery compartment, open the white
connector retainer and connect the two cables together as shown in the photo below.
6. To complete the battery installation, close the white connector retainer and reattach the battery door with
the three screws (torque of 8.7+/-1.7 lb-in).
2. Remove the battery container, jumpers and wire harness from the
battery compartment. Place the battery container and batteries onto a
flat surface. Use the provided jumper wires to connect the batteries in
series. Connect the positive terminal (red) of the battery to the negative
terminal (black) of another battery. See photo below for details.
4. Fold the battery container and seal it with tape.
Batteries Wiring and Installation Instruction for the UPS
Only use battery wires that have been provided with the UPS.
Warning: Do not service the 1609-SPD without disconnecting the power sources due to electric shock harzard for risk of severe
injury or death.
2
Publication 1609-IN012B-EN-P - August 2012 DIR 10000234085 (Version 01)
Notch
End
Red
Top
Red
Bottom
Black
Red
Red
Black
Black
Black
Notch
End