Rockwell Automation 1394C-SJT_CONN-KEY Installing Your Power Connector Key Kit - Manual (Page 2)

2 Installing Your 1394C Power Connector Key Kit
Publication 1394-IN023A-EN-P — July 2000
Installing the Key Kit Installation of your 1394C power connector key kit involves the
replacement of the system module power connector plugs and the
insertion of keys into specified system module terminals.
The replacement plugs are keyed and labeled to prevent an improper
power connection. Follow the procedure starting below to install your
1394C power connector key kit.
Removing the Power Connector Plugs
To remove the three power connector plugs:
1. Remove all 24V control power, contactor enable power, and
360/480V AC input power from the system.
!
ATTENTION: The 1394 system module contains
ESD (Electrostatic Discharge) sensitive parts and
assemblies. Static control precautions are required
when installing, testing, servicing, or repairing this
device. Component damage can result if ESD control
procedures are not followed. If you are not familiar
with static control procedures, refer to Guarding
Against Electrostatic Damage (publication
8000-4.5.2), or any other applicable ESD Protection
Handbook.
!
ATTENTION: This product contains stored energy
devices. To avoid hazard of electrical shock, wait five
minutes or verify that all voltage on the system bus
network has been discharged before attempting to
service or repair this unit. Only qualified personnel
familiar with solid state control equipment and safety
procedures in publication NFPA 70E or applicable
local codes should attempt this procedure.