Re-applying power to your 1394c system – Rockwell Automation 1394C-SJT_CONN-KEY Installing Your Power Connector Key Kit User Manual
Page 6
Advertising
6
Installing Your 1394C Power Connector Key Kit
Publication 1394-IN023A-EN-P — July 2000
Re-applying Power to Your 1394C System
To re-apply power to your 1394C system:
1. Re-connect the three connector plugs as shown in the table below
(refer to Figure 2 for connector locations
).
2. Re-apply power to your system.
3. Check for proper operation. Refer to your 1394 Digital AC
Multi-Axis Motion Control System User Manual (publication
1394-5.0) for additional start-up information.
Connect the plug
labeled:
Into this system module connector:
W1 W2
Input logic connector
U V W PE
Input power connector
COL INT DC+
Shunt power connector
Advertising