Rockwell Automation 931S-A1A1N-IP2 Passive Isolator, 2 Channel - Manual (Page 4)

4
3 Mounting and dismounting
3.1 Mounting onto TS 35 DIN rails
(Page 41, Fig. 1)
3.2 Pluggable electronic components for range alteration
(depending on model)
(Page 41, Fig. 2)
1. Remove connector, (depending on model either screw-type
or tension clamp).
2. Press locking clips on both sides of the enclosure.
3. Pull out the circuit board.
The circuit board can only be inserted in one position.
The connectors are all keyed to insure proper installation.
3.3 Labelling possibilities
1492-M5X10 markers can be used to label module.