Rockwell Automation 1787-DNPS DeviceNet Power Supply Installation Instructions - Manual (Page 3)

1787-5.8 - February 1999
DeviceNet Power Supply 3
3. Secure all necessary cords from the DeviceNet network in their
appropriate ports once the power supply is securely mounted.
4. Switch the main power switch to the on position to supply power to the
DeviceNet network.
Mounting Dimensions This figure illustrates the correct mounting dimensions:
Specifications Table 1 lists specifications for the DeviceNet power supply.
ATTENTION: For alternate usage at an input of 230V ac
operation, the cord must be “SVT” type or equivalent with
an IEC320-C13 connector and appropriate grounded plug.
Cord must be 1.8m to 3.0m in length and rated for 2500W
(250V/10A).
Be certain that the voltage selection switch is set for proper
input voltage before application of main power.
Vertical Mounting
Horizontal Mounting
304.8 mm
12 in
76.2 mm
3 in
98.6 mm
3.88 in
9.5 mm (.375 in) diameter
for all mounting holes
126.9 mm
5 in
149.7 mm
5.9 in
9.5 mm (.375 in) diameter
for all mounting holes
304.8 mm
12 in
ATTENTION: This product may, under certain circum-
stances, develop hot surfaces during operation. Make sure
that proper precautions are taken to avoid damage to either
equipment or human operators.