Rockwell Automation 1746-MPM INSTALL INSTRUC MOLD PRESSURE - Manual (Page 21)

Mold Pressure Module 21
Publication 1746-5.13 July 1998
The following warnings apply to products having CSA certification for use
in hazardous locations.
CSA logo is a registered trademark of the Canadian Standards Association.
!
ATTENTION: Explosion hazard:
• Substitution of components may impair suitability for
Class I, Division 2
• Do not replace components unless power has been
switched off or the area is known to be non-hazardous.
• Do not disconnect equipment unless power has been
switched off or the area is known to be non-hazardous.
• Do not disconnect connectors unless power has been
switched off or the area is known to be non-hazardous.
Secure any user-supplied connectors that mate to external
circuits on this equipment by using screws, sliding latches,
threaded connectors, or other means such that any
connection can withstand a 15 Newton (3.4 lb.) separating
force applied for a minimum of one minute.
• Batteries must only be changed in an area known to be non-
hazardous.