2 - use a memory card reader, Introduction, Change which project loads – Rockwell Automation Logix5000 Controllers Nonvolatile Memory Programming Manual User Manual
Page 27: Chapter 2, Use a memory card reader, Introduction change which project loads
Chapter 2
Use a memory card reader
A sample controller project that reads and writes a memory card is available with
the Logix Designer application. In the application, from the Help menu, choose
Vendor Sample Projects to display a list of available sample projects.
A memory card can store multiple projects. By default, the controller loads the
project that you most recently stored, according to the load options of that
project.
To assign a project to load from the memory card, edit the Load.xml file on the
card by following the steps that match the numbers in the illustration.
Description
To change the project that loads from the card, use a text editor to open the Load.xml file.
Edit the name of the project that you want to load.
• Use the name of an XML file that is in the CurrentApp folder.
• In the CurrentApp folder, a project is comprised of an XML file and a P5K file.
Introduction
Change which project loads
Rockwell Automation Publication 1756-PM017F-EN-P – October 2014
27