Chapter 3 - using an assembly connection, Chapter 3, Using an assembly connection – Rockwell Automation 1738 Assembly Connections for POINT I/O and ArmorPOINT I/O EtherNet/IP Adapters User Manual
Page 19
Advertising
13
Publication 1734-UM016A-EN-P - October 2010
Chapter
3
Using an Assembly Connection
Use an Assembly
Connection with
RSNetWorx for EtherNet/IP
This section provides an illustration of the steps needed to configure the
Assembly connection using RSNetWorx for EtherNet/IP.
1. Browse the EtherNet/IP network.
2. Select the connection originator that will make the connection to the
1734-AENT. Right click that device and select Scanlist Configuration to
launch the Scanlist Configuration tool.
Advertising
This manual is related to the following products: