Rockwell Automation 1771-P4S_P6S_P4S1_P6S1 Power Supply Modules Installation Instructions - Manual (Page 4)

Publication 1771-IN079A-EN-P - June 2002
4 Allen-Bradley Power Supply Modules
What this Power Supply
Package Contains When you receive your power supply, you should see the following
components in the box:
• RQH 3 6 3 6 3 6 RU 3 6 SRZHU VXSSO\ PRGXOH
• RQH SRVLWLRQ WHUPLQDO EORFN DWWDFKHG WR PRGXOH
Install the Power Supply To install the power supply, you need to know how to perform the following
tasks:
• VHW WKH MXPSHUV
• SODFH WKH SRZHU VXSSO\ LQ D FKDVVLV
• FRQQHFW D SDUDOOHOLQJ FDEOH LI XVLQJ D VHFRQG VXSSO\
• FRQQHFW LQSXW SRZHU
Set the Jumpers
Each power supply module has two jumpers located at the back edge of the
module near the gold-plated edge connectors. The jumper selection
provides the proper voltage regulation for the different power supply
configurations. The power supply can be configured to support local or
remote sensing by setting the jumpers.
To configure the supply:
3RVLWLRQ WKH SRZHU VXSSO\ PRGXOH VR WKDW WKH MXPSHUV DQG SLQV DUH
IDFLQJ XSZDUG DV VKRZQ EHORZ
6HW WKH MXPSHUV DV VKRZQ LQ WKH IROORZLQJ WDEOH 8VH QHHGOH QRVH SOLHUV
WR VHW WKH MXPSHUV
For this configuration Set jumpers to:
A single power supply in a power supply chassis
connected to an I/O chassis thru a power cable right position
All other configurations. (Power supplies are
shipped with jumpers in this position.) left position