Rockwell Automation 1746-XXXX SLC 500 32-Channel Digital I/O Modules Installation Instructions - Manual (Page 5)

SLC 500™ 32-Channel Digital I/O Modules 5
Publication 1746-IN028A-EN-P - October 2003
1. Disconnect Power
2. Align the circuit board of the
module with the chassis card
guide. (A)
3. Slide the module into the
chassis until the tip and
bottom tabs lock into place.
(B)
4. Refer to pages 16 through 19
for 32-point wiring
instructions.
5. Route the wires down and
away from the module,
securing them with the wire
tie. (C)
6. To keep the chassis free
from debris, cover all
unused slots with Card Slot
Filler, Catalog Number
1746-N2.
To remove the module, disconnect
wiring or pre-wired connector,
press and hold the module release
located on each self-locking tab
(D), and slide the module out of
the chassis slot.
C
B
D
A Slot 1