Rockwell Automation 1747-WINBAS Software Programming Manual - Manual (Page 24)

Publication 1747-PM001A-EN-P - January 2007
22 Getting Familiar With Your BASIC Interface Software
Configure DH-485
If you select DH-485 for the port and the BASIC software has never
made a connection via DH-485 previously, then the BASIC software
will open this dialog.
Select a Device
Port Configuration Dialog Options
Parameter Value
Connect using
COM1, COM2, COM3, COM4, or DH-485
(1)
(1) If you select DH-485, all other list boxes are disabled since the other parameters are not valid or set by RSLinx
software.
Bits per second 300, 1200, 2400, 4800, 9600, 19,200, 38,400, 57,600, or 115,200
Data bits 7 or 8
Parity None, even, or odd
Stop bits 1 or 2
Flow control None or Xon/Xoff
OK button
• Saves the configuration.
• Reconfigures the appropriate port.
• Exits the configuration dialog returning you to the BASIC
Interface main program.
Cancel button • Exits the configuration dialog returning you to the BASIC
Interface main program without saving any changes.
• Uses the previous configuration information to configure the
appropriate port.
X button • Exits the configuration dialog returning you to the BASIC
Interface main program without saving.
• Uses the previous configuration information to configure the
appropriate port.