Rockwell Automation 1771-QI,D17716.5.126 PLASTIC MOLD.MODULE User Manual
Reference manual
Advertising
Table of contents
Document Outline
- 1771-6.5.126, Plastic Molding Module Reference Manual
- Preface
- Table Of Contents
- Abbreviated Command and Status Blocks
- Chapter Contents
- DYC ú Dynamic Command Block
- HDC ú Hold Configuration Block
- HPC ú Pack/Hold Profile Block
- INC ú Injection Configuration Block
- IPC ú Injection Profile Block
- JGC ú Jog Configuration Block
- MCC ú Module Configuration Command Block
- PKC ú Pack Configuration Block
- PLC ú Plastication Configuration Block
- PPC ú Plastication Profile Block
- PRC ú Pre-decompression Configuration Block
- PSC ú Post- decompression Configuration Block
- PTC ú Process Trace Configuration Block
- RLC ú Inject ERC Values Block
- HPS ú Pack/Hold Profile Status Block
- IPS ú Injection Profile Status Block
- PPS ú Plastication Profile Status Block
- PTS ú Process Trace Status Block
- RLS ú Inject ERC Values Status Block
- SYS - System Status Block
- Chapter 2 -Command Word/Bit Descritions
- Alphabetical List of Command Blocks and Block ID Codes
- List of Data Words
- Engineering Units
- Data Blocks Require I/O Configuration
- Data Blocks for System Control
- Data Blocks for Controlling Ram (Screw) Position
- DYC ú Dynamic Command Block
- HDC ú Hold Configuration Block
- HPC ú Pack/Hold Profile Block
- INC ú Injection Configuration Block
- IPC ú Injection Profile Block
- JGC ú Jog Configuration Block
- MCC ú Module Configuration Command Block
- PKC ú Pack Configuration Block
- Plastication Configuration Command Block (PLC)
- PPC ú Plastication Profile Block
- PRC ú Pre-decompression Configuration Block
- PSC ú Post-decompression Configuration Block
- PTC ú Process Trace Configuration Block
- RLC ú Inject ERC Values Block
- Chapter 3 - Status Word
- List of Status Blocks and Block ID Codes
- List of Data Words
- Data Blocks Require I/O Configuration
- Engineering Units
- Status Blocks for Reporting System and Ram (Screw) Position Status
- HPS ú Pack/Hold Profile Status Block
- IPS ú Injection Profile Status Block
- PPS ú Plastication Profile Status Block
- PTS ú Process Trace Status Block
- RLS ú Inject ERC Values Status Block
- SYS ú System Status Block
- Chapter 4 - Programming Error Codes
- Chapter 5 - Sequencing Co-injection
- Chapter 6 - Module Specifications
- Chapter 7 - Calibration Instructions
- Calibration Equipment Required
- About This Procedure
- Map Your BTW and BTR Data Blocks
- Write Your Calibration Logic
- Set Internal Jumpers
- Wire the Wiring Arms
- Calibration Setup Using Optional Equipment
- Calibration Setup at the Machine Location
- Calibration Procedure for Inputs
- Calibration Procedure for Outputs
- Notes:
- Back Cover