Rockwell Automation 1771-ODD INSTL.DATA AC/DC (220/44)INPUT - Manual

Publication 1771Ć5.20 - January 1999
AC (120V) Isolated Output
Module, 16 Outputs
(1771-ODD Series B)
Use this document as a guide when installing the catalog number
1771-ODD series B output module.
To See page
Prevent Electrostatic Discharge 1
Understand Compliance to European Union Directives 2
Important Preinstallation Considerations
2
Calculate Power Requirements 4
Setting the Mode of the FuseĆBlown Jumper 4
Key the Backplane Connector 5
Install the Module andFieldWiring Arm 6
Connect Wiring to the FieldWiring Arm 7
For this reference information See page
Interpret the Status Indicators 9
Replacing a Fuse 10
CSA Hazardous Location 11
Specifications 12
The ac isolated output module is shipped in static-shielded packaging
to guard against electrostatic discharge damage. Observe the
following precautions when handling the module.
Electrostatic Discharge Damage
!
ATTENTION: Electrostatic discharge can damage
integrated circuits or semiconductors if you touch
backplane connector pins. Follow these guidelines
when you handle the module:
•
Touch a grounded object to discharge static potential
•
Wear an approved wrist-strap grounding device
•
Do not touch the backplane connector or
connector pins
•
Do not touch circuit components inside the module
•
If available, use a static-safe work station
•
When not in use, keep the module in its original
static-shielded packaging
Installation Instructions
Contents
Prevent Electrostatic
Damage