Rockwell Automation 1769-OW8I Compact Individually Isolated AC/DC Relay Output Module - Manual (Page 4)

4 Compact™ Individually Isolated AC/DC Relay Output Module
Publication 1769-IN053A-EN-P - April 2001
System Assembly
The module can be attached to the controller or an adjacent I/O module before or
after mounting. For mounting instructions, see "Panel Mounting" on page 6, or "DIN
Rail Mounting" on page 7. To work with a system that is already mounted, see
"Replacing a Single Module within a System" on page 7.
The following procedure shows you how to assemble the Compact I/O system.
1. Disconnect power.
2. Check that the bus lever of the module to be installed is in the unlocked
(fully right) position.
3. Use the upper and lower tongue-and-groove slots (1) to secure the modules
together (or to a controller).
4. Move the module back along the tongue-and-groove slots until the bus
connectors (2) line up with each other.
5. Push the bus lever back slightly to clear the bus locking tab (3). Use your
fingers or a small screwdriver.
6
5
4
3
1
1
2