Rockwell Automation 1769-OW8I Compact Individually Isolated AC/DC Relay Output Module - Manual (Page 9)

Compact™ Individually Isolated AC/DC Relay Output Module 9
Publication 1769-IN053A-EN-P - April 2001
A removable, write-on label is provided with the module. Remove the label from
the door, mark the identification of each terminal with permanent ink, and slide the
label back into the door. Your markings (ID tag) will be visible when the module
door is closed.
Removing the Finger-Safe Terminal Block
When wiring field devices to the module, it is not necessary to remove the terminal
block. If you remove the terminal block, use the write-on label on the side of the
terminal block to identify the module slot lcation and type.
To remove the terminal block, loosen the upper and lower retaining screws. The
terminal block will back away from the module as you remove the screws. When
replacing the terminal block, torque the retaining screws to 0.46 Nm (4.1 in-lbs).
Wiring the Finger-Safe Terminal Block
When wiring the terminal block, keep the finger-safe cover in place.
1. Loosen the terminal screws to be wired.
SLOT # _____
MODULE TYPE ______
wiring the
finger-safe terminal
block
upper retaining screw
lower retaining screw