Installing the module, Removing the module, Installing the module -7 removing the module -7 – Rockwell Automation 1746-NR8 SLC 500 RTD/Resistance Input Module User Manual User Manual
Page 27
Publication 1746-UM003A-EN-P
Installation and Wiring 2-7
Installing the Module
1.
1.
1.
1. Align the circuit board of the RTD module with the card guides located at
the top and bottom of the chassis, as shown in the following illustration.
2.
2.
2.
2. Slide the module into the chassis until both top and bottom retaining clips
are secured. Apply firm even pressure on the module to attach it to its
backplane connector. Never force the module into the slot.
3.
3.
3.
3. Cover all unused slots with the Card Slot Filler, Catalog Number 1746-N2.
Removing the Module
1.
1.
1.
1. Press the releases at the top and bottom of the module and slide the module
out of the chassis slot.
2.
2.
2.
2. Cover all unused slots with the Card Slot Filler, Catalog Number 1746-N2.
The RTD module contains an 24-position, removable terminal block. The
terminal pin-out is shown in the illustration on page 2-8.
Top and Bottom
Module Releases
Card
Guide