Rockwell Automation 1756-ENBT ControlLogix EtherNet/IP Bridge Module Installation Instructions - Manual

Publication 1756-IN019C-EN-P - November 2004
Installation Instructions
ControlLogix EtherNet/IP Bridge Module
Catalog Number 1756-ENBT
Use this document as a guide to install the module. Note that this document
describes hardware installation only. For configuration information, refer to
the EtherNet/IP Modules User Manual, publication number ENET-UM001,
available online at www.rockwellautomation.com/literature.
The following table lists the contents of this document and where to find
specific information.
Topic See Page
Important User InformationI 2
Identify Module Components 7
Prepare the Chassis for Module Installation 8
Determine Module Slot Location 9
Install the Module in the Chassis 10
Remove or Replace the Module (when applicable) 11
Install or Remove the Module Under Power 12
Wire the Ethernet Connector 13
Connect the Module to the EtherNet/IP Network 13
Apply Chassis Power 15
Check Power Supply and Module Status 15
Troubleshoot the Module 16
Where to Find Information on Configuring the Module 17
Specifications 18