Rockwell Automation 1784-U2CN USB-to-ControlNet Cable Installation Instructions - Manual (Page 3)

USB-to-ControlNet Cable 3
Publication 1784-IN047A-EN-P - November 2008
Environment and Enclosure
At the end of its life, this equipment should be collected
separately from any unsorted municipal waste.
ATTENTION
This equipment is intended for use in overvoltage Category II applications (as
defined in IEC publication 60664-1), at altitudes up to 2000 m (6562 ft) without
derating.
This equipment is considered Group 1, Class A industrial equipment according
to IEC/CISPR Publication 11. Without appropriate precautions, there may be
potential difficulties ensuring electromagnetic compatibility in other
environments due to conducted as well as radiated disturbance.
This equipment is supplied as enclosed equipment. It should not require
additional system enclosure when used in locations consistent with the
enclosure type ratings stated in the Specifications section of this publication.
Subsequent sections of this publication may contain additional information
regarding specific enclosure type ratings, beyond what this product provides,
that are required to comply with certain product safety certifications.
In addition to this publication, see the following publications:
• publication
1770-4.1 , Industrial Automation Wiring and Grounding
Guidelines, for additional installation requirements.
• NEMA Standards publication 250 and IEC publication 60529, as
applicable, for explanations of the degrees of protection provided by
different types of enclosures.