Rockwell Automation 1784-U2CN USB-to-ControlNet Cable Installation Instructions - Manual (Page 5)

USB-to-ControlNet Cable 5
Publication 1784-IN047A-EN-P - November 2008
Install the Cable
Follow these procedures to install the cable.
Obtain the Device Driver for the Cable
Follow these steps to download and install the device driver for the cable.
1. Visit http://www.rockwellautomation.com/knowledgebase/ .
2. Open tech note ID 55431 and follow the instructions in the tech note
to install the driver.
ATTENTION
This equipment is sensitive to electrostatic discharge, which can cause
internal damage and affect normal operation. Follow these guidelines when
you handle this equipment:
• Touch a grounded object to discharge potential static.
• Do not touch connectors or pins.
• Store the equipment in appropriate static-safe packaging when not in
use.
IMPORTANT
A minimum of RSLinx Classic software, version 2.51, is required for use with
the cable.
IMPORTANT
If RSLinx Classic software, version 2.54 or later, is installed on the computer,
the device driver is already installed on the computer. Skip this section.