Rockwell Automation 1785-LTx,D178510.3 QUICK START CLASSIC PLC-5 PROG - Manual (Page 12)

2–5 Set up the Hardware
Publication 1785Ć10.3 - October 1996
Install the PLCĆ5 Processor
Define the DH+ Station Address of Channel 1A
by setting switch assembly SWĆ1 on the back of
the processor.
Install the processor.
To install the battery, slide the batteryĆside
connector into the processorĆside connector
until you hear them snap together, and attach
the battery cover.
side view
Set Switch
assembly SW1
address here
OFF
Battery Connector
Battery Cover
Battery
1
2
4
More
For detailed information about handling and disposing of the battery
as well as other important guidelines, see publication AGĆ5.4.
If you plan to install an EEPROM, install it now.
3
Memory module slot
ATTENTION: Do not insert or remove the EEPROM under power.
Insertion or removal under power can result in loss of
program memory and a processor fault.
Top view of processor
Locking
Bar
PLC-5/25
Processor
Card Guides
Lift Eector Tab
For more information, see the Classic PLC-5 Programmable
Controllers Hardware Installation Manual, publication number
1785-6.6.1.
Powerup the System
Powerup the system. Check the LED display on the processor. If
your system is operating properly, the PROC LED should be steady
red. If the PROC LED is not red, see chapter 4 for troubleshooting
information before you install the I/O modules.
More