Rockwell Automation 1734-SSI POINT I/O Synchronous Serial Interface Absolute Encoder Module User Manual - Manual (Page 9)

1 Publication 1734-UM007D-EN-P - December 2005
Chapter
1
Install the Module
About This Chapter Read this chapter to learn about how to install, wire, and remove the
1734-SSI module.
About the Module The 1734-SSI module collects serial data from industrial
absolute-position encoding sensors that use a standard SSI protocol.
Insert the module into a POINT I/O terminal base that provides
common power, communication, and wiring connections for the SSI
sensors. Use this Series C module with the following.
• ControlNet adapter
with RSLogix 5000 software, version 11 or later
• DeviceNet adapter
• EtherNet/IP adapter
with RSLogix 5000 software, version 11 or later
• PROFIBUS adapter
24VDC Source Output
Module Status
Network Status
1734 OB4E
NODE:
0
1
2
3
Mounting Base
Mechanical Keying
(Orange)
Module Wiring Diagram
1
Module Locking Mechanism
Insertable I/O Module
RTB Removing Handle
Removable Terminal Block (RTB)
DIN Rail Locking Screw
(Orange)
Slide-in Writable Label
Interlocking Side Pieces
43122