Rockwell Automation 1756-NEX Nexus Module - Manual (Page 36)

4-2 Configure the 1756-CLX/C Module
Publication 1756-UM524B-EN-P - December 2008
Overview of the Configuration Process
When you use the RSLogix 5000 software to configure a 1756-CLX/C module, you must
perform the following steps:
1. Create a new module.
2. Accept the default configuration or change it to specific configuration for the
module.
3. Edit configuration for a module when changes are needed.
4. Configure the module’s IP address.
Create a New Module
After you have started RSLogix 5000 and created a controller, you must create a new
module. The wizard allows you to create a new module and write configuration. You can
use default configuration or write specific configuration for your application.
IMPORTANT
You must be offline when you create a new module
If you are not offline, use this
pull-down menu to go offline